In order to have the same color, I will use some spray paint and give it a few layers of paint. I passed two levels of sandpaper and they look better now. Finally, you should sandpaper all the parts, especially where we had supports, so we had a smoother finish. Anyway, now all parts are clean, more or less. So carefully remove everything from the inside and all the small holes. But the middle part has a lot of supports. For the jaw and the top part of the skull, that was easy. As you can see one was printed with two colors and that’s because while I was printing it, which by the way, it was around 30 hours of printing time, I was running out of grey filament so I had to pause the print and continue with gold color. Everything was printed with PLA material, 0.4mm nozzle and 0.2mm layer height and 20% infill and 2 perimeters. Inside the skull we have a lot of support for the 3D printing process. You have to print all of the parts using supports because none of them is flat and they all have round shapes. The jaw, the bottom part of the skull and the top part. First of all, we need the 3D printed skull so download my designs from below and 3D print it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |